From Knoppix Documentation Wiki
|
|
(24 intermediate revisions by 15 users not shown) |
Line 1: |
Line 1: |
− | 1.)
| + | {{delete|outdated}} [[User:WPSchulz|WPSchulz]] ([[User talk:WPSchulz|talk]]) 19:12, 11 April 2016 (EDT) |
− | The Knoppix V4.0 DVD did not boot and hung. In debug mode i found that there were ACPI warnings "executable code found at module level". The solution to this was to remove the USB card reader I had plugged in. After that the boot sequence finished ok. I do not know if this error is worth being tracked. I cannot really make a connection between ACPI and a USB device. If anyone is interested in the issue I will send additional data.
| + | |
− | | + | |
− | | + | |
− | | + | |
− | 2.)
| + | |
− | Knoppix needs a povray raytracing engine if it is to have KPovModeller. Here is the error:
| + | |
− | | + | |
− | i) Load up Graphics--> KPovModeller.
| + | |
− | ii) (It comes up with a basic scene).
| + | |
− | iii) Hit View--> Render
| + | |
− | iv) It gives the error message: "Couldn't call povray. Please check your installation or set another povray command."
| + | |
− | | + | |
− | A discussion of possible workarounds (including my wishlist) can be found at: http://www.knoppix.net/forum/viewtopic.php?p=88147#88147 . I would note that I entered it into a feature request at that forum and was directed to report this as a bug. Paipix 3.6 FWIW does not give this error because it has a povray engine. (submitted by PterandoN, pterandon)
| + | |
Latest revision as of 23:12, 11 April 2016
Template:Delete WPSchulz (talk) 19:12, 11 April 2016 (EDT)