Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
A-Tech 8GB DDR3 1600 PC3-12800 Laptop SODIMM 204-Pin Memory RAM PC3L DDR3L 1x 8G
$13.99
Crucial DDR3L 16GB 1600 2x 8GB PC3-12800 Laptop SODIMM Memory RAM PC3 16G DDR3
$21.50
HyperX FURY DDR3 8GB 16GB 32GB 1600 MHz PC3-12800 Desktop RAM Memory DIMM 240pin
$15.90
Crucial DDR3L 16GB 1600 2x 8GB PC3-12800 Laptop SODIMM Memory RAM PC3 16G DDR3
$13.50
A-Tech 8GB PC3-12800 Desktop DDR3 1600 MHz Non ECC 240-Pin DIMM Memory RAM 1x 8G
$13.99
32GB ECC DDR3 RAM 2x16GB PC3L-12800R Desktop/Server Memory
$11.99
16GB DDR4 Corsair Vengeance LPX 3000 Mhz 1.35V Desktop Computer PC Memory RAM
$26.99
Pair Kingston HyperX FURY 16GB (2X8GB) PC3-14900 DDR3-1866Mhz Non-ECC Memory
$18.95
A-Tech 128GB 8x 16GB 2Rx4 PC4-19200R DDR4 2400 ECC REG RDIMM Server Memory RAM
$175.92
A-Tech 256GB 4x 64GB 4Rx4 PC4-19200 ECC Load Reduced LRDIMM Server Memory RAM
$287.96