Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
Fortinet FortiSwitch FS-124D-POE 24 Port Gigabit Ethernet Switch UNREGISTERED
$99.97
Cisco Catalyst C9300-24UX-A 24 Port 10G/mGig UPOE Network Switch, no module
$349.97
ARUBA J9772A 2530-48G PoE+ 48 PORT ETHERNET SWITCH W/ RACK EARS J9772-60301
$125.69
Cisco SG300-10P 10x PoE RJ45 Gigabit Switch SRW2008P-K9 V03 + Power Adapter
$49.99
NETGEAR GS305300PAS 5 Port Gigabit Ethernet Unmanaged Switch
$15.99
New Linksys SE3005 5-port Gigabit Ethernet Switch
$18.99
Linksys SE3008 8 Ports Rack Mountable Gigabit Ethernet Switch
$21.99
TP-Link TL-SG1005P 5-Port Gigabit Desktop Switch with 4-Port PoE QTY AVAILABLE
$14.99
Dell X1018 X-Series Smart Managed Switches 16-Port Gigabit 2-Port SFP Switch
$65.00
HP JG937A Flexnetwork 5130-48G PoE+ 48-Port Gigabit Network Switch
$63.95